Netgear WG302v1 Firmware 4.0.4

• 
• Download Netgear WG302v1 Firmware 4.0.4

Netgear WG302v1 Firmware 4.0.4 description

OSSupport:Windows Size:3.9 MB
NETGEAR has been a worldwide provider of technologically advanced, branded networking products since 1996. Our mission is to be the preferred customer-driven provider of innovative networking solutions for small businesses and homes.Note: Upgrade to Netgear WG302v1 Firmware 4.0.4 version only if you need WPA2. Otherwise, use firmware version 3.0.7.Note! * Besides the firmware, you also need extract the patch.txt file from the zip download. * If upgrading from Version 1.0.5 or earlier, you MUST follow Netgear WG302v1 Firmware 4.0.4 special upgrade procedure. Please write down all your configuration information before upgrading * If upgrading from Version 2.01 or later, you may use the Upgrade page in the Web interface. If you have problems after upgrading, please follow the instructions in Part 2 on this page (To Upgrade the Firmware Using TFTP). Remember to write down your configuration before doing the upgrade.http://kbserver.netgear.com/release_notes/d102701.asp Whats New 1. Support for WPA2.Bugs Fixed 1. Fixed the Web GUI firmware upgrade occasional failed problem. 2. Fixed occasionally client cannot reassociate the AP problem.Known Issues and Limitations 1. Wireless bridging and wireless repeating are not available when AutoCell is enabled. Wireless bridging and wireless repeating requires the access points to use the same channel. This conflicts with AutoCells automatic channel selection. 2. When WG302s built-in DHCP server for wireless clients is enabled, if there is another DHCP server on the LAN, the wireless client may get IP address from the DHCP server on the LAN instead of the WG302. WPA and WPA-PSK wont work with wireless bridging or wireless repeating. 3. If the WEP passphrase was set up through CLI, the Web UI doesnt display the correct WEP encryption status. 4. SuperG and Dynamic 108 support is not optimized. To use 108 Mbps, disable SuperG, manually set up wireless setting to channel 6, 802.11g and 108 data rate. 5. SuperG will not work with AutoCell. SuperG requires an access point to run on channel 6, which conflicts with AutoCells automatic channel selection. If you’re using adapters WG511, WG511T, WAG511 or WAG311, get the latest driver and utility frojm this site. These support WPA-PSK. 6. You must select the WEP key index 2, 3 or 4 instead of 1 when using 802.1x+WEP authentication. 7. You must set a valid primary Radius accounting server to use the secondary Radius accounting server. 8. If the primary DNS server is not available, then the secondary DNS will not work.

Netgear WG302v1 Firmware 4.0.4 Tag: